UBIFS

Page under construction... Informations on this page are not guaranteed !!

This is a preliminary page dealing with the installation of UBIFS on the APF boards. UBIFS will replace JFFS2 file system on NAND based board because JFFS2 induces a big overhead when parsing, reading and writing on NAND devices UBISFS scalability

Introduction

UBIFS website

Setting up

• host system: add mtd-utils uuid uuid-dev packages:

 sudo apt-get install  uuid-dev

• buildroot: target filesystem -> ubifs root filesystem (0x1F800, 0x800, 2047)
• linux: file systems -> Miscellanous -> ubifs support and disable debugging !!
• linux: device driver -> mtd -> ubi unsorted block image -> Enable UBI (4096) and disable debugging !!

• uboot: setenv bootcmd run ubifsboot
• uboot: setenv download_rootfs tftpboot ${loadaddr} ${serverpath}${board_name}-rootfs.arm.ubifs

Additional informations

A new file 'ubinize.cfg' defining the ubi volumes is located in target/device/armadeus/ this file contains the different UBI volumes of the UBI image:

• [ubifs]
• mode=ubi
• vol_id=0
• vol_type=dynamic
• vol_name=rootfs
• vol_alignment=1
• vol_flags=autoresize

This file is processed by the ubinize utility after mkfs.ubifs.